data seg reloc to 0x00004004 <--> 0x00005634 bss seg reloc to 0x00005640 <--> 0x00005AF8 Checking 256 megs/ 4 banks...no Checking 128 megs/ 2 banks...no Checking 128 megs/ 4 banks...yes [NeTTrom] Ver. 2.3.3-rfs2 (c) 1997,1998,1999,2000 REBEL.COM [NeTTrom] Built on Jun 6 2002 08:47:00 [NeTTrom] Bios version 00.00.01. [NeTTrom] Detected Memory 0x08000000 bytes in 0x00000004 banks, board id 59FF. [NeTTrom] FootBridge Vendor ID [0x00001011] Device ID [00001065] rev.[03] [NeTTrom] WinBond IDE Vendor ID [0x000010AD] Device ID [00000565] rev.[10] [NeTTrom] Ether10 Vendor ID [0x00001050] Device ID [00005A5A] rev.[00] [NeTTrom] IGS CyberPro Vendor ID [0x000010EA] Device ID [00002010] rev.[01] [NeTTrom] Initializing kbd...[KBD]: Keyboard reset failed, no ACK [NeTTrom] Mapping in /romdev/vga..VGA option regs(30 71 72): 000000. Video RAM: Detecting bus width...32 bit Video RAM: Detecting size...[4MB=NO][2MB=NO][1MB=YES] [NeTTrom] Mapping in /romdev/ide..waiting for disk spin-up.. [NeTTrom] IDE Disk: LBA supported: total 0x012BB230 sectors. Press '*' TWICE to enter debug......AutoBoot commencing... Kernel GZIP compressed image recognized... Setting up section table at 0x07FFC000 Enabling MMU and caches..done uncompress_image(): Decompressing...done ELF kernel recognized elf_load(): [Checking section 0x00][loadable, size 0x000DC78B] elf_load(): [Checking section 0x01][loadable, size 0x0000EF64][zeroing] Initrd: scan 0x00314910 bytes @ 0x000EB6F0. e.n.t.r.r.r.r.r.r.r.r.r.r.y. d.one. start_kernel() ELF kernel: ...setup_arch() pci: DEC Tulip fast ethernet Board rev:0x000059FF, serial #:0x00001AB7. ...into vga_init Slider base: 0x00000201 WaveArtist base: 0x00000250 WA IRQ: 0x00000003 WA 16-bit DMA: 0x00000007 Sound Blaster base: 0x00000220 Sound Blaster IRQ: 0x00000003 Sound Blaster 8-bit DMA: 0x00000001 AdLib base: 0x00000388 SoundBlaster DSP reset (expect 0xAA): 0x000000AA SoundBlaster DSP id: 0x00000103 ...paging_init() swapper_pg_dir @ 0xC0008000 ...trap_init() ...init_IRQ() ...sched_init() ...time_init() ...parse_options() ...init_modules() ...console_init() ...kmalloc_init() ...calibrate_delay() ...start_kernel() done No keyboard detected... going serial at 115200 8N1, port ttyS0. Board ID: 59FF.10, Serial: 6839, Memory: RAM 128 Mb, flash 1 Mb. hda: HITACHI_DK229A-10, 9590MB w/512kB Cache, CHS=16383/16/63, LBA scsi: 0 hosts. scsi: detected total. eth0: NE2000+ found at 0x300, using IRQ 8, (32 bit). eth1: Digital DS21142/3 Tulip at 0xe1400000, 00 10 57 c0 1a b7, IRQ 9. Autoboot - Press the 'star' key to abort autoboot [5 *4 NeTTrom command-> setenv kernfile /boot/vmlinux-netwinder3 NeTTrom command-> boot cmd=console=ttyS0,115200 data seg reloc to 0x00004004 <--> 0x00005634 bss seg reloc to 0x00005640 <--> 0x00005AF8 [NeTTrom] Second level jump mode [FB B0=0x00000046][FB B1=0x02000046][FB B2=0x04000046][FB B3=0x06000046] [Kern loc=0x07C00000] [VGA_30=0x00][VGA_71=0x13][VGA_72=0x00] [VGA_B2=0xDB][VGA_B3=0x54] [CMD=ide0=autotune video=800x600 console=ttyS0,115200 nwconsole=serial netconfig_eth0=disk netconfig_eth1=disk ] ELF kernel recognized elf_load(): [Checking section 0x00][loadable, size 0x001910C3][zeroing] Initrd: scan 0x00087CE9 bytes @ 0x07D990C3. Kernel entry point 0x00008000 Press '*' TWICE to enter debug......Booting kernel... Linux version 2.4.19-rmk6-nw1 (othmar@debussy) (gcc version 2.95.4 20011002 (Debian prerelease)) #5 Thu Feb 13 01:57:08 CET 2003 CPU: StrongARM-110 revision 4 Machine: Rebel-NetWinder On node 0 totalpages: 32768 zone(0): 32768 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: ide0=autotune video=800x600 console=ttyS0,115200 nwconsole=serial netconfig_eth0=disk netconfig_eth1=disk ide_setup: ide0=autotune Console: colour dummy device 80x30 Calibrating delay loop... 166.70 BogoMIPS Memory: 128MB = 128MB total Memory: 127832KB available (1266K code, 281K data, 236K init) Dentry cache hash table entries: 16384 (order: 5, 131072 bytes) Inode cache hash table entries: 8192 (order: 4, 65536 bytes) Mount-cache hash table entries: 2048 (order: 2, 16384 bytes) Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) POSIX conformance testing by UNIFIX PCI: DC21285 footbridge, revision 03, in central function mode PCI: bus0: Fast back to back transfers disabled PCI: Ignore bogus resource 1 [3f6:3f6] of Symphony Labs SL82c105 PCI: Ignore bogus resource 3 [376:376] of Symphony Labs SL82c105 pci: init done. Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket netwinder_led_event: hw set to 00000002 Starting kswapd VFS: Diskquotas version dquot_6.4.0 initialized CyberPro2010: enabling PCI bursts CyberPro2010: 1024KiB VRAM, using 800x600, 35.157kHz, 56Hz Console: switching to colour frame buffer device 100x37 initialize_kbd: Keyboard reset failed, no ACK Detected PS/2 Mouse Port. pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled keyboard: Timeout - AT keyboard not present?(ed) keyboard: Timeout - AT keyboard not present?(f4) ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10e Thermostat: high 55.0, low 53.0, current 43.0 C, fan on. NetWinder Button Driver Version 0.3 (C) Alex Holden 1998. Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx W82C105: IDE controller on PCI bus 00 dev 61 W82C105: chipset revision 5 W82C105: 100% native mode on irq 14 ide0: BM-DMA at 0x60a0-0x60a7, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0x60a8-0x60af, BIOS settings: hdc:DMA, hdd:DMA hda: HITACHI_DK229A-10, ATA DISK drive hda: selected PIO 4 (120ns) (0240) ide0 at 0x60c0-0x60c7,0x3f6 on irq 14 hda: 19640880 sectors (10056 MB) w/512KiB Cache, CHS=19485/16/63, (U)DMA Partition check: hda: hda1 hda2 hda3 hda4 ne2k-pci.c:v1.02 10/19/2000 D. Becker/P. Gortmaker http://www.scyld.com/network/ne2k-pci.html eth0: Winbond W89C940F found at 0x6080, IRQ 21, 00:10:57:00:1A:B7. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 8192) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: AppleTalk 0.18a for Linux NET4.0 NetWinder Floating Point Emulator V0.97 (double precision) VFS: Mounted root (ext2 filesystem) readonly. Freeing init memory: 236K INIT: version 2.78 booting Welcome to NetWinder Linux Press 'I' to enter interactive startup. Mounting proc filesystem [ OK ] Configuring kernel parameters [ OK ] Setting clock (utc): Thu Feb 13 02:33:32 /etc/localtime 2003 [ OK ] Activating swap partitions [ OK ] Setting hostname jay [ OK ] Checking root filesystem modprobe: modprobe: Can't locate module char-major-10-151 failed to open /dev/led: No such device Could not open /dev/led. Check that it exists, and create with 'mknod -m600 /dev/led c 10 151' if needed. /dev/hda1: clean, 118667/1912832 files, 2060665/7645144 blocks [/sbin/fsck.ext2 -- /] fsck.ext2 -a /dev/hda1 [ OK ] modprobe: modprobe: Can't locate module char-major-10-151 failed to open /dev/led: No such device Could not open /dev/led. Check that it exists, and create with 'mknod -m600 /dev/led c 10 151' if needed. Remounting root filesystem in read-write mode [ OK ] Hardware config already completed. Finding module dependencies [ OK ] Checking filesystems failed to open /dev/led: No such device Could not open /dev/led. Check that it exists, and create with 'mknod -m600 /dev/led c 10 151' if needed. /dev/hda3: clean, 64928/526336 files, 1041429/2097648 blocks Checking all file systems. [/sbin/fsck.ext2 -- /usr] fsck.ext2 -a /dev/hda3 [ OK ] failed to open /dev/led: No such device Could not open /dev/led. Check that it exists, and create with 'mknod -m600 /dev/led c 10 151' if needed. Mounting local filesystems [ OK ] Turning on user and group quotas for local filesystems [ OK ] Enabling swap space [ OK ] Current fan setting: ON. New fan setting: ON. INIT: Entering runlevel: 3 Entering non-interactive startup Setting network parameters [ OK ] Bringing up interface lo [ OK ] Bringing up interface eth0 [ OK ] Starting portmapper: [ OK ] Starting system logger: [ OK ] Starting kernel logger: [ OK ] Starting identd: [ OK ] Starting at daemon: [ OK ] Starting cron daemon: [ OK ] Starting sshd [ OK ] Starting xntpd: [ OK ] Starting NFS services: [ OK ] Starting NFS quotas: [ OK ] Starting NFS mountd: [ OK ] Starting NFS daemon: [ OK ] Checking /etc/inittab for only serial console Disabling virtual consoles in /etc/inittab INIT: no more processes left in this runlevel